Table of Contents
Advertisement
If your ISP specifies that you use PPTP (Point-to-Point Tunneling Protocol) as your connection
to the Internet, you cannot use the provided Setup Wizard to automatically set up your router.
Follow the instructions below to set up your connection manually:
1. Remove the Ethernet cable from the back of the computer you currently connect with,
and connect it to the Internet port of your Router.
2. Connect the Ethernet cable provided to any of the four LAN ports, and the other end to
your computer.
3. Configure your computer's Ethernet adapter to obtain an address automatically.
4. See Windows Help for information on how to configure your computers network
adapter.
NOTICE: If you are charged for your Internet Connection by the minute, unplug the
network cable from the Internet port on the Router when Internet access is no
longer desired.
Back to Top
Save & Apply
Use the Save & Apply page to submit all the network setting changes you have made. Click
the Save & Restart button to update the network configurations for your Router.
New settings are written to the firmware, and the Router reboots automatically.
NOTE: If you have wireless clients in your network, you must configure the clients' wireless
network cards to match the settings for the Router.
Save and Apply
Advertisement
Table of Contents
