KEENCUT Javelin Instructions

Cutter bars

Hide thumbs Also See for Javelin:

CUTTER BARS

INSTRUCTIONS

Thankyou for choosing the Keencut Javelin, Practik

or Max. Every effort has been made to bring you a

superbly built product with the promise of many years

of good service.

L A R G E F O R M A T C U T T E R

Keencut – the world's finest cutting machines

Keencut Limited, Tyson Courtyard, weldon South Industrial Estate,

Corby, Northants, ENGLAND NN18 8AZ.

Telephone: 01536 263158 Facsimile: 01536 204227

E-mail: info@keencut.co.uk Website: www.keencut.co.uk

Table of Contents

Need help?

Do you have a question about the Javelin and is the answer not in the manual?

Page 1 CUTTER BARS INSTRUCTIONS Thankyou for choosing the Keencut Javelin, Practik or Max. Every effort has been made to bring you a superbly built product with the promise of many years of good service. L A R G E F O R M A T C U T T E R Keencut –...
Page 2 WARNING It is essential that the Javelin, Practik or Max is used on a flat surface to cut accurately. A warped or bowed table top can induce a twist in the Javelin, Practik or Max resulting in a bowed cut.
Page 3 Position the material under the Javelin, Practik or Max and align the sight edge with your cutting marks. The Javelin, Practik or Max will cut within 0.5 to 1mm [0.02” to 0.04”] of the sight edge, this small gap allows easier alignment when cutting to the edge of an image.
Page 4 Cleaning and lubrication It is good practice to keep a dust sheet over the Javelin, Practik or Max if it is not to be used for extended periods. In any event regularly clean it with a dry cloth, to remove any stubborn stains use a cloth dampened with a little water/detergent.

PractikMax