Advertisement
Table of Contents
SIMPLEX
Inspired Design – Precision Engineering
USER INSTRUCTIONS
Thank you for choosing the Keencut SIMPLEX. Every effort
has been made to bring you a precision engineered product
with the promise of many years of valuable service. In order to
obtain maximum benefit from your machine please read these
instructions carefully. For advice and assistance or replacement
parts please contact your distributor or Keencut.
Keencut Limited, Baird Road, Willowbrook Industrial Estate, Corby, Northants, ENGLAND NN17 5ZA.
Telephone: 01536 263158 Fax: 01536 204227 E-mail: info@keencut.co.uk
www.keencut.co.uk
Advertisement
Table of Contents
Related Manuals for KEENCUT SIMPLEX
Summary of Contents for KEENCUT SIMPLEX
- Page 1 For advice and assistance or replacement parts please contact your distributor or Keencut. Keencut Limited, Baird Road, Willowbrook Industrial Estate, Corby, Northants, ENGLAND NN17 5ZA. Telephone: 01536 263158 Fax: 01536 204227 E-mail: info@keencut.co.uk www.keencut.co.uk...
- Page 2 SAFETY blade must be removed first. WARNING It is essential that the MAX/SIMPLEX is used on a flat surface to cut accurately. A warped or bowed table top can induce a twist in the SIMPLEX resulting in a bowed cut.
- Page 3 Position the material under the SIMPLEX and align the sight edge with cut line of the material. The SIMPLEX will cut within 0.5 to 1mm [0.02” to 0.04”] of the sight edge, this small gap allows easier alignment when cutting to the edge of an image.
- Page 4 Cleaning and lubrication It is good practice to keep a dust sheet over the SIMPLEX if it is not to be used for extended periods. In any event regularly clean it with a dry cloth, to remove any stubborn stains use a cloth dampened with a little water/detergent.
Need help?
Do you have a question about the SIMPLEX and is the answer not in the manual?
Questions and answers