Government Regulations - AstroStart DSP625 Owner's Manual

Government Regulations

This device complies with Part 15 of FCC rules. Operation is subject to the following
two conditions: (1) This device may not cause harmful interference, and (2) This device
must accept any interference received, including interference that may cause undesirable
operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to
provide reasonable protection against harmful interference in a residential installation.
This equipment generates and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to
radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or
television, which can be determined by turning the equipment OFF and ON, the user is
encouraged to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
Remote Controls
To satisfy FCC RF exposure compliance requirements, this device should be used in hand-
held, hand operated configurations only. The device and its antenna must maintain a
separation distance of 20 cm or more from the person's body, except for the hand and
wrists, to satisfy RF exposure compliance. This device is designed to be used in a person's
hands and its operating configurations do not support normal transmissions while it is
carried in pockets or holsters next to a person's body.
Antenna
To satisfy FCC RF exposure compliance requirements, the device and its antenna must
maintain a separation distance of 20 cm or more from the person's body, except for the
hand and wrists, to satisfy RF exposure compliance.
This device complies with the Industry Canada Radio Standards Specification RSS 210. Its
use is authorized only on a no-interference, no-protection basis; in other words, this device
must not be used if it is determined that it causes harmful interference to services authorized
by IC. In addition, the user of this device must accept any radio interference that may be
received, even if this interference could affect the operation of the device.
WARNING! Changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this device.
12 © 2017 Directed. All rights reserved.