Manual Valet Modes; Emergency Override; Battery Information - AstroStart DSP625 Owner's Manual

• Combo Valet (
The Combo Valet command is used to turn on/off both Alarm Valet and
Start Valet together.
- If both Valets are off then both will be turned on.
- If one or both Valets are on, then they will be turned off.
The 2-way remote control confirms by using LED and tones.

Manual Valet Modes

Use the following routine to manually turn on/off the Valet Modes, turning both
on manually achieves Combo Valet:
Turn the ignition ON and then OFF.
1.
• Alarm Valet:
Press and release the Valet button once.
Alarm Valet will turn on/off accordingly. The antenna LED will be on
while Alarm Valet is on and will be off when Alarm Valet is off. The
siren/horn also sounds to confirm.
• Start Valet:
Press and hold the Valet button for five seconds.
The parking lights flash nine times in rapid succession when turned on,
and nine times in slow succession when turned off. The 2-way remote
control confirms by using LED and tones.

Emergency Override

The following procedure Disarms the system when a programmed remote is not
available. Number of presses__________
Turn the ignition ON.
1.
Press the Valet button the correct number of times (the default is 1 press).
2.
After a few seconds the siren output ceases and the system is Disarmed.

Battery Information

The 2-way remote control (2625-TX) is powered by two batteries (CR-2016).
The 1-way remote control (2615-TX) is powered by one 3V coin cell lithium
battery (CR-2032) that can be purchased at most retailers. When the battery
begins to weaken, the operating range will be reduced.
10
x4 + )
© 2017 Directed. All rights reserved.