MATTRESS FIRM 500 Owner's Manual
Hide thumbs Also See for 500:
Table of Contents

Advertisement

Available languages

Available languages

owners manual
 500
ENGLISH
SPANISH

Advertisement

Chapters

Table of Contents
loading

Summary of Contents for MATTRESS FIRM 500

  • Page 1  500 ENGLISH SPANISH...
  • Page 3: Table Of Contents

    contents contents Advisory ........................4 Acoustics ........................6 Fabric Cleaning Information ..................6 Installation ......................... 7 USB / Power Outlet / Underbed Light / Flat ..............11 Power Down Operation ....................12 Remote Control Function .................... 14 Remote Control Programming ..................15 Troubleshooting ......................
  • Page 4: Advisory

    Do not should not operate this base without adult supervision. apply lubricant to lift motor lead screws or any nylon nuts or the base may inadvertently creep downward from the elevated position. 500 Adjustable Base Owners Manual 99301625-d...
  • Page 5: Step

    In the event the technician is unable to perform service due to lack of accessibility, the service call will be billed to the purchaser and the service will have to be rescheduled. 500 Adjustable Base Owners Manual 99301625-d...
  • Page 6: Acoustics

    Hot water extraction or steam the middle of the affected area to prevent circling. cleaning is not a recommended cleaning method. Use a professional furniture cleaning service when an overall soiled condition is apparent. 500 Adjustable Base Owners Manual 99301625-d...
  • Page 7: Installation

    DUAL SYNC CABLE (for leg installation) (split sizes only) (4 pieces) POWER SUPPLY (power brick, electrical feed 3 - AAA BATTERIES cord, and electrical power cord) factory attached to base, no assembly required REMOTE CONTROL 500 Adjustable Base Owners Manual 99301625-d...
  • Page 8 (FIGURE 3). Repeat at each corner of the base. FIGURE 2 PLASTIC WASHER (placed over threaded insert) FIGURE 3 LEGS – SCREW INTO THREADED INSERT AT EACH CORNER 500 Adjustable Base Owners Manual 99301625-d...
  • Page 9: Figure

    OF REMOTE DOOR CONTROL PRESS IN ON TAB AND LIFT OUT TO REMOvE BATTERY COMPARTMENT DOOR. INSERT TABS IN TAB SLOTS AND SNAP IN TO REPLACE. steP 8 Return base to the level position. 500 Adjustable Base Owners Manual 99301625-d...
  • Page 10: Figure

    THIS PRODUCT SHOULD NOT BE USED WITH EITHER A DUST RUFFLE OR A MATTRESS ENCASEMENT. IF EITHER A DUST RUFFLE OR MATTRESS ENCASEMENT IS NEEDED, THEN A MATTRESS RETAINER BAR IS REqUIRED. Typical adjustable base installation is now complete. 500 Adjustable Base Owners Manual 99301625-d...
  • Page 11: Usb / Power Outlet / Underbed Light / Flat

    / flat feature The 500 Model bases are also equipped with underbed light and flat switches located on either side of the base. Press in on underbed light switch to turn underbed light on and off. Press and hold flat switch to lower base to level position (FIGURE 6).
  • Page 12: Power Down Operation

    Install (2) 9 volt batteries in power brick (FIGURE 8). FIGURE 8 BATTERY COMPARTMENT DOOR (push down and slide off to remove) UNDERSIDE OF POWER BRICk INSTALL (2) 9 vOLT BATTERIES *BATTERIES NOT INCLUDED 500 Adjustable Base Owners Manual 99301625-d...
  • Page 13: Adjustable Base Owners Manual 99301625-D

    Remove two (2) 9 volt batteries from power brick. Plug power cord back into electrical power source (FIGURE 10). When power is restored from outage, base is ready to resume normal operation. FIGURE 10 500 Adjustable Base Owners Manual 99301625-d...
  • Page 14: Remote Control Function

    To revert back to factory settings, simultaneously press and hold the SET button and the FLAT button. The massage motor will turn on and off confirming the change. Your base is now set to factory settings. Note: Cust 1 and Cust 2 positions will revert to factory preprogrammed positions. 500 Adjustable Base Owners Manual 99301625-d...
  • Page 15: Remote Control Programming

    On the remote control, simultaneously press and hold the HEAD UP and FLAT buttons (FIGURE 12) until the indicator light goes off on the control box One remote control is now programmed to operate one base. 500 Adjustable Base Owners Manual 99301625-d...
  • Page 16 On base 1, plug one of the male sync cable plugs into the sync port of the toggle switch control box, mounted to the underside of the base, near the control box (FIGURE 14). FIGURE 14 TOGGLE SWITCH CONTROL BOx CONTROL SYNC PORT 500 Adjustable Base Owners Manual 99301625-d...
  • Page 17 To revert back to factory settings, simultaneously press and hold the SET button and the FLAT button on either of the remote controls. The massage motor and underbed light will turn on and off confirming the change. Your base is now set to factory settings. 500 Adjustable Base Owners Manual 99301625-d...
  • Page 18 You will hear an audible click after each push. Then, the indicator light and the underbed light will light up (FIGURE 16). FLAT BUTTON FIGURE 16 CONTROL INDICATOR LIGHT FIGURE 17 LEARN PORT 500 Adjustable Base Owners Manual 99301625-d...
  • Page 19: Troubleshooting

    • If base is installed over a bed frame, verify massage motors are not causing bed frame (or bed frame components) to vibrate. • Verify that headboard attachment hardware is tightened firmly (if used). 500 Adjustable Base Owners Manual 99301625-d...
  • Page 20: Accessories

    ACCESSORY DESCRIPTION CODE IMAGE Headboard Brackets-TXL, FXL-Q 4B8846 3” Legs (set of 4) 4B2284 5” Legs (set of 4) 4B7270 Pin-Adjustable Legs (set of 4) 4B8740 Mattress Retainer (bushings preinstalled in base) 4B8524 500 Adjustable Base Owners Manual 99301625-d...
  • Page 21: Warranty

    5th year since the Warranty Commencement Date, you would be responsible for paying: $100 part cost divided by 7, multiplied by 2 = $28.57. 500 Adjustable Base Owners Manual 99301625-d...
  • Page 22 You and the service will have to be rescheduled. Mattress Firm Customer Service toll free phone: 844-MATT-FRM online: mattressfirm.com PLEASE DO NOT CONTACT YOUR RETAIL DEALER OR ANY OTHER SERvICE PERSONNEL 500 Adjustable Base Owners Manual 99301625-d...
  • Page 23 contenido contents Recomendaciones ...................... 24 Acústica ........................26 Información sobre la limpieza de tapicería ..............26 Instalación ........................ 27 Enchufe USB / Toma de corriente/ Iluminación debajo de la cama/ Posición plana (horizontal) ..31 Operación En Caso De Interrupción Eléctrica ............... 32 Funcionamiento Del Control Remoto ................
  • Page 24: Recomendaciones

    Manual del propietario base ajustable 500 99301625-d...
  • Page 25 PUNTOS DE ATRAPAMIENTO TíPICOS el técnico no pueda realizar el servicio debido a falta de accesibilidad, la llamada de servicio se le cobrará al comprador y el servicio se tendrá que programar para otra fecha. Manual del propietario base ajustable 500 99301625-d...
  • Page 26: Acústica

    Utilice un servicio extracción con agua caliente o la limpieza con vapor profesional de limpieza de muebles cuando sea no son métodos de limpieza recomendados. aparente una condición de suciedad generalizada. Manual del propietario base ajustable 500 99301625-d...
  • Page 27: Instalación

    (solo tamaños de dos (4 piezas) piezas) FUENTE DE ALIMENTACIÓN (bloque de 3 - BATERíAS AAA alimentación, cable eléctrico y cable de alimentación eléctrica) conectada de fábrica a la base; no requiere CONTROL REMOTO ensamble Manual del propietario base ajustable 500 99301625-d...
  • Page 28 (FIGURA 3). Repita en cada esquina de la base. FIGURA 2 ARANDELA DE PLÁSTICO (colocada sobre el inserto roscado) FIGURA 3 PATAS – SE ATORNILLAN EN EL INSERTO ROSCADO EN CADA ESqUINA Manual del propietario base ajustable 500 99301625-d...
  • Page 29 DE LA BATERíA DEL CONTROL OPRIMA LA LENGÜETA Y LEvANTE REMOTO HACIA AFUERA PARA RETIRAR LA CUBIERTA DEL COMPARTIMIENTO DE LA BATERíA. INSERTE LAS LENGÜETAS EN LAS RANURAS CORRESPONDIENTES Y PRESIONE PARA vOLvER A COLOCARLA. Manual del propietario base ajustable 500 99301625-d...
  • Page 30 UN vOLANTE O UN CUBRE COLCHÓN. EN CASO DE qUE SE NECESITE UN vOLANTE O UN CUBRE COLCHÓN, SE REqUIERE UNA BARRA DE RETENCIÓN DEL COLCHÓN. Ha completado la instalación típica de la base ajustable. Manual del propietario base ajustable 500 99301625-d...
  • Page 31: Enchufe Usb / Toma De Corriente/ Iluminación Debajo De La Cama/Posición Plana (Horizontal)

    / toMa de corriente/ iluMinaciÓn debaJo de la caMa/PosiciÓn Plana (HoriZontal) encHufe usb / toMa de corriente Las bases del modelo 500 están equipadas con enchufes USB y tomas de corriente que funcionan ubicados en cada lado de la base que le permiten cargar dispositivos electrónicos de bajo voltaje, como teléfonos celulares,...
  • Page 32: Operación En Caso De Interrupción Eléctrica

    Instale (2) baterías de 9 voltios en el bloque de alimentación (FIGURA 8). FIGURA 8 CUBIERTA DEL COMPARTIMIENTO DE LA BATERíA (empuje hacia abajo y deslice hacia afuera para removerla) PARTE BAjA DEL BLOqUE DE ALIMENTACIÓN INSTALE (2) BATERíAS DE 9 vOLTIOS *BATERíAS NO INCLUIDAS Manual del propietario base ajustable 500 99301625-d...
  • Page 33 Vuelva a conectar el cable de energía a la fuente de alimentación eléctrica (FIGURA 10). Cuando se reestablece la energía después de la sobrecarga, la base está lista para volver a operar normalmente. FIGURA 10 Manual del propietario base ajustable 500 99301625-d...
  • Page 34: Funcionamiento Del Control Remoto

    PLANA (FLAT). El motor de masaje se apagará y encenderá confirmando el cambio. Ahora su base está ajustada a la configuración de fábrica. Nota: Las posiciones Cust 1 y Cust 2 se revertirán a las posiciones preprogramadas de fábrica. Manual del propietario base ajustable 500 99301625-d...
  • Page 35: Programación Del Control Remoto

    SUBIR LA CABEzA y botón de POSICIÓN PLANA (FIGURA 12) hasta que la luz indicadora desaparezca de la caja de control. Ahora, un control remoto está programado para operar una base. Manual del propietario base ajustable 500 99301625-d...
  • Page 36 En la base 1, conecte uno de los enchufes macho del cable de sincronización en el puerto de sincronización de la caja de control de interruptores alternadores montada en la parte inferior de la base, cerca de la caja de control (FIGURA 14). Manual del propietario base ajustable 500 99301625-d...
  • Page 37 (FLAT) en cualquiera de los controles remotos. El motor de masajes y la iluminación debajo de la cama se encenderá y apagará confirmando el cambio. Su base está ahora configurada a la configuración de la fábrica. Manual del propietario base ajustable 500 99301625-d...
  • Page 38 Luego, la luz indicadora y la iluminación debajo de la cama se encenderá (FIGURA 16). BOTÓN DE FIGURA 16 POSICIÓN PLANA CAjA DE (FLAT) CONTROL INDICADOR DE LUz PUERTO DE FIGURA 17 APRENDIzAjE Manual del propietario base ajustable 500 99301625-d...
  • Page 39: Resolución De Problemas

    (o los componentes del bastidor de la base) no estén provocando que vibre el bastidor de la base. • Verifique que las piezas adjuntas de la cabecera están apretadas de modo firmen (si se utilizan). Manual del propietario base ajustable 500 99301625-d...
  • Page 40: Accesorios

    Soportes de cabecera-gemelas TXL, doble XL/Q 4B8846 Patas de 3” (juego de 4) 4B2284 Patas de 5” (juego de 4) 4B7270 Pata ajustable con pasador (juego de 4) 4B8740 Retenedor de colchón (casquillos preinstalados en la base) 4B8524 Manual del propietario base ajustable 500 99301625-d...
  • Page 41: Garantía 1-3-10

    5º año a partir de la fecha de inicio de la garantía, Usted será responsable de pagar: el costo de la parte en cuestión $100, dividido entre 7 y luego multiplicado por 2 = $28,57. Manual del propietario base ajustable 500 99301625-d...
  • Page 42 Servicio al cliente Mattress Firm teléfono sin cargo: 844-MATT-FRM en línea: mattressfirm.com POR FAvOR, NO CONTACTE A SU COMERCIANTE MINORISTA O A CUALqUIER OTRO PERSONAL DE SERvICIO Manual del propietario base ajustable 500 99301625-d...
  • Page 44 99301625-d EDR13912 1/17 nationwide custoMer service (844) Matt-frM toll free: © 2017 Mattress Firm, Inc.

Table of Contents