Download
Share
Print this page
MATTRESS FIRM 600 Owner's Manual
  1. Manuals
  2. Brands
  3. MATTRESS FIRM Manuals
  4. Indoor Furnishing
  5. 600
  6. Owner's manual

MATTRESS FIRM 600 Owner's Manual

Adjustable base
Hide thumbs Also See for 600:

Advertisement

Quick Links

600
Adjustable Base
owner manual
H-122 T/F/Q

Advertisement

loading

Related Manuals for MATTRESS FIRM 600

Summary of Contents for MATTRESS FIRM 600

  • Page 1 Adjustable Base owner manual H-122 T/F/Q...

  • Page 3: Table Of Contents

    CONTENTS Advisory ........................4 Assembly ........................6 Remote Control Function .................... 10 Power Down Operation ....................11 Troubleshooting ......................12 Warranty ........................13 READ ALL INSTRUCTIONS BEFORE USING If adjustable base does not operate or if parts are missing, call: 844-MATT-FRM REGISTER YOUR BASE To register your base, go to:...

  • Page 4: Advisory

    ADVISORY IMPORTANT INFORMATION READ THE FOLLOWING INFORMATION CAREFULLY BEFORE USING THIS PRODUCT SERVICE REQUIREMENTS Service technicians are not responsible for moving WARNING furniture, removing headboards and footboards or any items required to perform maintenance on the base. In FOR OPTIMUM ADJUSTABLE BASE the event the technician is unable to perform service due OPERATION, USE A GROUNDED, ELECTRICAL to lack of accessibility, the service call will be billed to...
  • Page 5 ADVISORY IMPORTANT INFORMATION READ THE FOLLOWING INFORMATION CAREFULLY BEFORE USING THIS PRODUCT SMALL CHILDREN / PETS WARNING FCC COMPLIANCE After the base is unboxed, immediately dispose of packaging The equipment has been tested and found to comply with material as it can smother small children and pets. To avoid the limits for a Class B digital device, pursuant to Part injury, children or pets should not be allowed to play under 15 of the FCC Rules.

  • Page 6: Assembly

    ASSEMBLY To assemble adjustable base, complete the following procedure: STEP 1 Place adjustable base shipping carton on solid, level surface. Remove top section of shipping carton. Remove hardware box. Cut orange zip-tie from electrical power supply (attached to base frame). CAUTION: EXERCISE CAUTION WHEN USING SHARP INSTRUMENTS.
  • Page 7 ASSEMBLY STEP 2 WARNING Extend power cord out head end of base. POWER CORDS MUST NOT INTERFERE WITH STEP 3 ANY ADJUSTABLE BASE MECHANISMS. Cut (2) orange zip-ties securing mattress retainer (FIGURE 1). Set mattress retainer aside. CAUTION: EXERCISE CAUTION WHEN USING SHARP INSTRUMENTS.
  • Page 8 ASSEMBLY STEP 5 WARNING Rotate the base in the bottom shipping carton onto its edge, and then rotate the base over onto DUE TO RISK OF INJURY, TWO ADULTS its legs. ARE REQUIRED TO HANDLE AND MOVE ADJUSTABLE BASE. Note the USB Charging Stations located on each side of the base at the head section (FIGURE 3).
  • Page 9 ASSEMBLY STEP 10 Install the mattress retainer by placing the mattress retainer ends in the holes at the foot end of the base. Make sure horizontal bar section is flush against the base (FIGURE 4). FIGURE 4 MATTRESS RETAINER STEP 11 Place mattress on base to complete assembly.

  • Page 10: Remote Control Function

    REMOTE CONTROL FUNCTION SNORE BUTTON FOOT UP BUTTON Press to adjust the base to the factory default snory Press and hold to raise the foot section. position. To reprogram, adjust the base, massage, ZG (ZERO GRAVITY) BUTTON and underbed light to the desired position. Press Press to adjust the base to the factory default ZG and hold the Set button until the massage motors position.

  • Page 11: Power Down Operation

    POWER DOWN OPERATION Use this procedure to lower the base to flat during a power outage. Do NOT put batteries in power down device until necessary for use. Note: Power down device uses 9-volt alkaline batteries, which are not included. STEP 1 Insert (2) 9-volt alkaline batteries into the power brick (FIGURE 5).

  • Page 12: Troubleshooting

    TROUBLESHOOTING If the adjustable base fails to operate, investigate the symptoms and possible solutions provided in the chart below: SOLUTION SYMPTOM • Program the remote control (see Remote Control Programming section of this manual for programming procedures). • Unplug power cord, wait 30 seconds and plug in to reset electronic components.

  • Page 13: Warranty

    (whether in transit or by other means), subjected to physical or electrical abuse or misuse, or otherwise operated in any manner inconsistent with the operation and Mattress Firm Customer Service maintenance procedures outlined in the Owner’s Manual and this toll free phone: 844-MATT-FRM warranty;...
  • Page 16 290-0139-b EDR15255 4/19 NATIONWIDE CUSTOMER SERVICE (844) MATT-FRM toll free: © 2019 Mattress Firm, Inc.