MATTRESS FIRM 500 Owner's Manual page 17

"Press & Hold" to "one toucH" PrograMMing (1 remote control - 2 bases)
to cHange froM "Press & Hold" to "one toucH" PrograMMing
steP 1
Adjust base to the flat position.
steP 2
Simultaneously press the HEAD MASSAGE DOWN and FOOT MASSAGE DOWN buttons on either of the remote
controls. The massage motors and underbed light will turn on and off confirming the change.
WHEN IN "ONE TOUCH" MODE:
Cust 1 and Cust 2 buttons
One touch button. Base will adjust to the programmed position. Press any other button to stop the base during
movement.
Flat button
Flat button always remains "press & hold." When pressed and held, base will shut off massage motor, if active, and
adjust base to level position.
REvERT BACk TO FACTORY SETTINGS
To revert back to factory settings, simultaneously press and hold the SET button and the FLAT button on either
of the remote controls. The massage motor and underbed light will turn on and off confirming the change. Your
base is now set to factory settings.
17
500 Adjustable Base Owners Manual 99301625-d