MATTRESS FIRM 500 Owner's Manual page 18

Separate Two Bases - for independent adjustable base movement,
perform the following numbered procedure.
steP 1
Unplug both bases from electrical power outlet. Position
both bases on their sides, in close proximity to each other.
CAUTION: AT LeAST TWO PeOPLe ARe ReCOmmeNDeD
FOR HANDLING AND mOVING ADJUSTABLe BASe.
steP 2
Locate the toggle switch control box on both bases.
Locate dual sync cable plugged into the sync port of both
toggle switch control boxes. Unplug the dual sync cable
from the sync ports (FIGURE 15). Remote 1 should now
operate base 1 and remote 2 should operate base 2 once
the bases are plugged in. If remotes do not operate the
bases, proceed to step 3.
FIGURE 15
UNPLUG DUAL
SYNC CABLE
FROM SYNC
PORT
steP 3
Plug base 1 into electrical power outlet. On the control
box for base 1, using a pointed object, push the learn port
in two times in rapid succession. You will hear an audible
click after each push. Then, the indicator light and the
underbed light will light up (FIGURE 16).
FIGURE 16
18
500 Adjustable Base Owners Manual 99301625-d
reMote control PrograMMing (separating 2 bases)
TOGGLE SWITCH
CONTROL BOx
CONTROL
BOx
INDICATOR
LIGHT
LEARN
PORT
steP 4
On remote control 1, simultaneously press and hold the
head up and flat buttons (FIGURE 17) until the indicator
light goes off on the control box.
steP 5
Repeat Steps 3 & 4 with base 2 and remote control 2.
steP 6
Turn both bases over so they are resting on their legs.
CAUTION: AT LeAST TWO PeOPLe ARe ReCOmmeNDeD
FOR HANDLING AND mOVING ADJUSTABLe BASe.
Independent remote control operation is now
restored (remote control 1 operating base 1; remote
control 2 operating base 2).
HEAD UP
BUTTON
CONTROL
BOx
BASE 1
REMOTE CONTROL 1
BASE 2
REMOTE CONTROL 2
FIGURE 17
FLAT
BUTTON