Advertisement
Available languages
Available languages
Quick Links
STEP 1
Remove top of shipping carton. Verify contents;
inspect for damage.
Adjustable Base
setup guide
n 300/600 n T/F/Q
x4 - Pin-adjustable
Legs
x3 - AAA Batteries
x1 - Mattress
Retainer
291-0069-D EDR 16020 4/21
© 2021 Mattress Firm, Inc.
READ ALL INSTRUCTIONS BEFORE USING.
WARNING
!
DUE TO RISK OF INJURY, TWO ADULTS ARE
REQUIRED TO HANDLE AND MOVE ADJUSTABLE
BASE.
SNORE
HEAD
PILLOW
FOOT
ZGRAV
HEAD
FOOT
HEAD
FOOT
MEM
FLAT
ON/OFF
HEAD
FOOT
x1 - Remote
M1
SET
M2
M3
FLAT
M4
Control (varies
according to
base type)
300
600
x1 - Sync Cable
600 Model
(Split Sizes Only)
Advertisement
Related Manuals for MATTRESS FIRM 300
Summary of Contents for MATTRESS FIRM 300
- Page 1 Adjustable Base setup guide n 300/600 n T/F/Q READ ALL INSTRUCTIONS BEFORE USING. STEP 1 Remove top of shipping carton. Verify contents; WARNING inspect for damage. DUE TO RISK OF INJURY, TWO ADULTS ARE REQUIRED TO HANDLE AND MOVE ADJUSTABLE BASE.
- Page 2 SETUP WARNING CAUTION POWER CORDS MUST NOT INTERFERE WITH ANY BE CAREFUL USING SHARP INSTRUMENTS. INJURY ADJUSTABLE BASE MECHANISMS. IS POSSIBLE IF TOOLS ARE NOT USED PROPERLY. DO NOT WEAVE CORDS THROUGH BASE STRUCTURE. STEP 2 Cut zip-tie from electrical power supply (FIGURE 1) and extend power cord out the head end of the base.
- Page 3 SETUP STEP 5 Rotate base over onto its legs. STEP 6 Install (3) batteries in remote control. Plug power cord into power outlet. Note: An electrical SNORE PILLOW HEAD FOOT surge protection device is recommended (not included). ZGRAV HEAD FOOT Operate remote control to test base functions (FIGURE 3) HEAD FOOT...
- Page 4 Base Ajustable, guía de configuración n 300/600 n T/F/Q LEA TODAS LAS INSTRUCCIONES ANTES DE USAR. PASO 1 Retire la sección superior del contenedor de envío. Verifique ADVERTENCIA el contenido; compruebe que no haya daños. DEBIDO AL RIESGO DE LESIONES, SE REQUIERE DE DOS ADULTOS PARA MANIPULAR Y MOVER LA BASE AJUSTABLE.
- Page 5 CONFIGURACIÓN PRECAUCIÓN ADVERTENCIA LOS CABLES DE ALIMENTACIÓN NO DEBEN TENGA CUIDADO AL UTILIZAR INSTRUMENTOS INTERFERIR CON NINGÚN MECANISMO DE LA BASE AFILADOS. PUEDE HABER RIESGO DE LESIONES SI AJUSTABLE. NO PASE LOS CABLES A TRAVÉS DE LA NO USA ADECUADAMENTE LAS HERRAMIENTAS. ESTRUCTURA DE LA BASE.
- Page 6 CONFIGURACIÓN PASO 5 Gire la base sobre sus patas. PASO 6 Instale las (3) baterías en el control remoto. Enchufe la base a una fuente de alimentación eléctrica. SNORE HEAD PILLOW FOOT Nota: Se recomienda utilizar un dispositivo de protección ZGRAV HEAD FOOT...
-
Page 8: Need Help
Troubleshooting section of the owner’s manual. To download a copy of the owner’s manual, visit https://lpadjustablebeds.com/om/mattressfirm or call Mattress Firm at 844-628-8376. ¿NECESITA AYUDA? REGISTRE SU BASE Para registrar su base, vaya a: Si la base ajustable no funciona, consulte la Guía de https://lpadjustablebeds.com/register...