Table of Contents
Advertisement
MSA
3.4
Instrument Setup
This section describes the configuration options that are available through the
Options Setup menus. These menus can be accessed only when the
instrument is turned ON while pressing and holding the [
(see Sections 3.2 and 7.3).
This mode can only be activated at instrument turn-ON.
The operation is as follows:
(1) Press and hold the [
•
Use the [
The default password is "672".
(2)
Press [
] button to enter the setup menus.
•
Incorrect password: instrument enters the Measure mode.
•
Correct password: instrument continues/beeps three times.
The password can be changed through the MSA Link software.
In the Setup mode:
Press the [
] button to store chosen value or go to the next page.
•
] button to increase values by one or toggle a selection ON or
•
Press [
OFF.
Press and hold [
•
•
Press [
] button to decrease values by one or toggle a selection ON or
OFF.
Press and hold [
] button to decrease values by 10.
The following options are available by pressing the [
•
Sensor Setup (
SENSOR SETUP
•
Calibration Setup (
Alarm Setup (
•
ALARM SETUP
•
Setup Time and Date (
•
EXIT
] button while turning the instrument ON.
] and [
] buttons to enter the setup password.
] button to increase values by 10.
) - see Section 3.4.1
) - see Section 3.4.2
CAL SETUP
) - see Section 3.4.3
) - see Section 3.4.4
TIME SET
ALTAIR 4 - Operating Manual
OPERATION
] button
] and [
] buttons:
29
Hide quick links:
Advertisement
Table of Contents
