Table of Contents
Advertisement
Hot undocking using the Control Center:
1.
Make sure the computer's hot key driver is installed for hot docking/undocking the system.
2.
Press the Fn + Esc key combination to run the Control Center.
3.
Click the docking icon
4.
The docking icon will change to the undock icon
message will appear in the notification area of the taskbar (see over).
3
Figure E - 12 - Using the Control Center to Hot Undock the Computer
in the Control Center (the icon displays the current docking status).
1
1
1
3
Hot Undocking the Computer from the Docking Station E - 15
to display the current status and the Undock Complete
2
2
Docking Station Guide
Battery Condition
Note that if you attempt to
hot undock the
system
when the battery level is low
(default below 10%) you will
receive an error message.
In this case shut the system
down to cold undock the
notebook from the docking
station, or let the battery
charge sufficiently until it is
no longer classed at a low
level.
Advertisement
Table of Contents
