Housing; Dirt Container; Rotary Brush; Storage - Silvercrest SABD 3.7 LI C2 Operating Instructions Manual

ATTENTION! PROPERTY DAMAGE!
► Do not use abrasive or aggressive cleaning
materials. These may damage the surfaces.

Housing

■ Wipe off the appliance housing with a damp
cloth. If required, use a mild washing-up liquid
on the cloth.
■ Ensure that the appliance is completely dry be-
fore reconnecting it with the battery charger

Dirt container

To ensure that the performance of the cordless
sweeper does not deteriorate, empty the dirt
container after every use.
■ Press the push-in connection
container and pull it off.
■ Empty the dirt container
onto the appliance so that it sits firmly on the
appliance and clicks into place on the release
knob .

Rotary brush

If the rotary brush stops turning because of a
severe dirt accumulation or because threads have
caught around it, proceed as follows:
Dismount the rotary brush
observe Figures E and F on the fold-out page in
this instruction manual:
1) Turn the cordless sweeper around and hold it
so that the rotary brush
2) Pull the hook on the locking appliance
take the side cover
3) Pull the rotary brush
appliance and then pull it out to the side.
4) Remove any dirt (on both sides of the brush
bristles) and clean the rotary brush
this, take a damp cloth and wipe the individual
bristle bundles from the inside to the outside.
│ GB │ IE │ NI
■ 6
on the dirt
and push it back
. While doing this,
is facing you.
and
off.
upwards out of the
. To do
Replace the rotary brush
1) Push the round side of the rotary brush
the drive shaft
2) In Push the square end of the rotary brush
into the housing so that the rotary brush
straight in the housing again.
3) Replace the cover
Ensure that the locking appliance engages
properly.
.

Storage

ATTENTION! PROPERTY DAMAGE!
► Ensure that the appliance is switched off
before putting it away. Otherwise the battery
could be damaged by excessive discharging.
■ Store the cleaned appliance in a clean, dust-free
and dry place.

Troubleshooting

The appliance will not start.
■ The battery is discharged. Recharge the appli-
ance.
■ The appliance is defective. Contact the
Customer Service department.
The rotary brush
when revolving.
■ The rotary brush
brush .
■ The rotary brush
Check whether the rotary brush
fitted and correct the fitting if required.
.
.
and screw it down firmly.
generates loud noises
is soiled. Clean the rotary
is not inserted properly.
is correctly
SABD 3.7 LI C2
onto
sits