Table of Contents
Advertisement
Installing and wiring telephone power supplies
See
Figure 53: Expanded power distribution unit
distribution unit. To install the expanded power distribution unit:
1. Set the spacer bracket onto the mounting plate and secure with the #8-32 x 1/2-inch
shoulder screws. The spacer bracket is not shown in the figure but is installed behind the
top power distribution unit.
2. Slide the keyhole slots in the power distribution unit over the shoulder screws.
3. Insert the #8-32 x 1-inch screw through the distribution unit, through the spacer bracket, and
into the plate. The mounting hole is located just above the wire clip. Tighten the screw
securely.
4. Set the battery back-up switch to the 1-32 (down) position.
5. Power-down the 1145B2 unit as described on the label on the side of the unit.
6. Remove the output power cable between the 1145B2 and the 1146B2 units. The cable will
not be reused.
7. Connect the P1 connector end of the "T" cable to the bottom power distribution unit.
Connect the P2 connector to the top distribution unit. Connect the P3 connector to the
1145B2.
8. Power-up the 1145B2 as described on the label on the side of the unit.
Powering up and testing the power supply
Table 20: Power supply LEDs
when lit.
To power up and test the power supply:
1. Connect the AC power cord to the power supply and route the cord to an appropriate AC
outlet using the clips provided on the unit.
Note:
A maximum of four power supplies can be powered from one dedicated 100–120
Note:
V, 50/60 Hz, 20-amp feeder or 200–240 V, 50/60 Hz, 10-amp feeder. Use only
nonswitched outlets.
116 Installing and Connecting the MDF and Telephones
on page 116 describes the meaning of the power supply LEDs
Table 20: Power supply LEDs
LED
Meaning
color
Green
Power Supply is providing power
Yellow
Battery is charging
Red
Power Supply is on battery reserve
on page 113 while installing the power
Advertisement
Table of Contents
