Validate-Group Command; Set Qos Policy-Source Command - Avaya P130 User Manual

Chapter 6 Avaya P130 CLI

Validate-group Command

Use the validate-group command to verify that all the rules in a priority list are
valid.
If there is a configuration problem with a specific rule, or with a number of rules,
detailed error messages will be given.
The syntax for this command is:
validate-group <policy-list-number>[quiet]
quiet
Example:
P130-N(super)# validate-group 101

Set qos policy-source Command

Use the set qos policy-source command to set the policy source. The default
policy source is policy-server.
Note: Before configuring the IP access list, you must change the policy source mode
to local.
The syntax for this command is:
set qos policy-source <source>
<source>
Example:
P130-N(super)# set qos policy-source local
124
Does not display error messages
local | policy-server
Avaya P130 User's Guide