Set Port Redundancy Command; Show Port Redundancy Command - Avaya P130 User Manual

Chapter 6 Avaya P130 CLI

Set port redundancy Command

Use the set port redundancy command to define/remove redundancy
schemes between a Primary and a Secondary link. The link can be any port that does
not belong to a LAG, or a LAG interface. In either case, there should not be any
redundancy scheme already defined on any of the links.
The syntax for this command is:
set port redundancy <mod_num>/<prim_port_num> <mod_num>/
<second_port_num> {on/off} [<redundancy_name>]
<mod_num>
<prim_port_num>
<second_port_num>
<redundancy_name>
Example:
P130-1# set port redundancy 1/7 2/12 on red1
uplink: Port 2/12 is redundant to port 1/7.
Port redundancy is active - entry is effective immediately

Show port redundancy Command

Use the show port redundancy command to display information about all
redundancy schemes defined in the switch.
The syntax for this command is:
show port redundancy
Example:
P130-N> show port redundancy
Redundancy Name
---------------
fast
uplink
78
Module number
Primary link of the redundancy scheme
Secondary link of the redundancy scheme
Name for the redundancy scheme (optional)
Primary Port Secondary Port
------------ --------------
1/7
1/13
Status
------
2/12 enable
3/20 enable
Avaya P130 User's Guide