Set Snmp Trap Commands - Avaya P130 User Manual

Chapter 6 Avaya P130 CLI

Set snmp trap Commands

Use the set snmp trap commands to add an entry into the SNMP trap receiver
table and to enable or disable the different SNMP traps for a specific receiver. First
add the rcvr_addr and then enable/disable the different traps for it.
The syntax for this command is:
set snmp trap <rcvr_addr>
set snmp trap <rcvr_addr> {enable|disable} {all|config|fault|...}
enable
disable
all
config
fault
rcvr_addr
Example:
To enable SNMP ConfigChange traps to a specific manager:
P130-1# set snmp trap 192.122.173.42 enable config
SNMP config change traps enabled.
To enable all traps to a specific manager:
P130-1# set snmp trap 192.122.173.42 enable all
All SNMP traps enabled.
To disable SNMP config traps to a specific manager:
P130-1# set snmp trap 192.122.173.42 disable config
SNMP config traps disabled.
To add an entry in the SNMP trap receiver table with default:
P130-1# set snmp trap 192.122.173.42
SNMP trap receiver added.
116
Activate SNMP traps
Deactivate SNMP traps
(Optional) Specify all trap types
(Optional) Specify the ConfigChange trap from the TRAP-MIB.
(Optional) Specify the Fault trap from the TRAP-MIB.
IP address or IP alias of the system to receive SNMP traps
Avaya P130 User's Guide