Table of Contents
Advertisement
User Manual of DS-3WF03C-D
Chapter 14 Appendix-A
Troubleshooting
1. The device cannot be started after power on.
1) The Ethernet cable between the DS-3WF03C-D device and the POE adaptor is more
than 40 meters long.
2) The Ethernet cable quality is not good enough, and it should be Cat 5e or even Cat 6
cable.
3) The RJ-45 plugs are not well connected.
2. Cannot be restored to the factory setting
Please manually push the Reset button for 5~10 seconds until all LEDs are light on, then
the user can log in the device by typing the default IP address
192.168.1.36/192.168.1.35.
3. My computer cannot be connected to the DS-3WF03C-D Access Point.
Please try the following method to solve the problem:
1) Adjust the direction of the DS-3WF03C-D device.
Please rotate the DS-3WF03C-D device since the antenna inside the device is
directional.
2) Switch to other wireless channel
Switch to other wireless channel cause there are much interferences in this
channel.
3) Turn off the other interference sources
Maybe there are other WIFI devices nearby and cause interferences. Try to turn off
other WIFI devices nearby, or move DS-3WF03C-D to another clean environment.
4. The signal strength between 2 DS-3WF03C-D devices is too weak, and
throughput is low.
Outdoor Video Wireless Network Bridge
43
Advertisement
Table of Contents
