Igniter Replacement; Glass Replacement - Quadra-Fire CB1200MI-MBK Owner's Manual

C. Igniter Replacement
a. Be sure the appliance is allowed to cool, has been
unplugged and the exhaust blower is off. Remove the
ash pan.
b. The wire leads to the igniter are connected to the wire
harness with 1/4 inch male / female spade connectors.
These wires will pull forward approximately 4 to 5 inches
(102mm to 127mm). Disconnect the spade connections
and remove the igniter from the chamber. Loosen the
thumb screw and slide igniter out.
c. Install new igniter into the chamber and tighten the
thumb screw. Re-connect the wires to the 2 leads with
the spade connectors.
d. Push excess wire leads to take-up the 4 to 5 inches
(102mm to 107mm) previously pulled out. This will
keep the wires out of the way of the ash pan. Double
check that the igniter wires are clear of any movement,
i.e. ash pan, fire pot cleaning rod, etc.
f. Re-install the ash pan and re-connect the power.
Igniter Bracket
Figure 21.1
D. Glass Replacement
WARNING
• Glass is 5mm thick high temperature heat-resis-
tant ceramic glass.
• DO NOT REPLACE with any other material.
• Alternate material may shatter and cause injury.
• Remove door from appliance and place face down on
a protected surface to avoid scratching the door.
• Remove all door rope.
1. Replacing Center Glass
NOTE: DO NOT LET Air Wash Spacers fall down from
top frame when removing and replacing center
glass.
a. Be sure the appliance is allowed to cool, has been
unplugged and the exhaust blower is off.
b. Using a nut driver remove the (5) bottom nuts and
remove the bottom glass frame. Figure 21.2.
c. Slightly bend up and out of the way the 2 center posts
and slide the glass out the bottom.
d. Slide new glass in, reposition the 2 center posts and
re-install bottom glass frame.
e. Re-rope the door.
November 28, 2017
Igniter
Thumb Screw
2. Replacing Side Glass
NOTE:
When removing the side glass with the door
latch, you must remove the door latch first
before removing the side frame. Use a pow-
ered Phillips head screw driver to remove the
4 screws.
a. Be sure the appliance is allowed to cool, has been
unplugged and the exhaust blower is off.
b. Remove side glass frame.
c. Loosen the top and bottom frame and slightly bend
up and out of the way.
d. Slide glass out the side and slide new glass in.
e. Re-install the side glass frame and tighten the top
and bottom frames.
f. Re-install the door latch, if applicable, and re-rope
the door.
Figure 21.3
Remove Door Latch First
and then Side Frame
Figure 21.4
Handle glass assembly with care.
When cleaning glass:
• Avoid striking, scratching or slamming
• Do NOT clean glass when it is hot.
• Do NOT use abrasive cleaners.
• Use a hard water deposit glass cleaner on white film.
• Refer to maintenance instructions.
7014-286B
CB1200 Pellet Insert
Door Latch
Top & Bottom Frame
Center Posts
Glass
Door Frame
shown with no
Glass or Glass
Frames
Remove 5 nuts from Bottom Frame
CAUTION
glass.
Side
Frame
21