Table of Contents
Advertisement
After making all your choices, in submenu 1, enter these selections
by pressing the 'MENU' button which will momentarily flash
"STORED" on the display.
If the item selected in submenu 1 has a submenu 2 associated with
it, press the 'MIN' button to go to submenu 2. Select your choice
by pressing the 'MAX' button and enter your choice by pressing
the 'MENU' button.
Pressing the 'RESET' button one time brings you back one
'MENU' item, pressing the 'RESET' button two times returns you
to the run mode (this also results in a hard reset of peak and valley
and your setpoints).
Proceed through the flow chart below entering the values listed in
the Sub Menu 1 and 2 columns.
MENU
SUBMENU 1 SUBMENU 2 DESCRIPTION
L1CNF
L2CNF
L3CNF
L4CNF
INPUT
BRIDGE
RDG.CNF RDG.1=0
RDG.2=0
RDG.3=0
RDG.4=1
RDG.5=
RDG.6=
RDG.7=0
RDG SC
0.06250
RDG OF
0000000
Skip past
Skip past
Skip past
Skip past
Meter's input.
Scaling y=mx+b
Active decimal point
Normal display brightness
Leading zeros suppressed
Disregard not used
Disregard not used
External hard reset vs
only peak reset
See calculations above
8-31
8
Scaling to
Display
Engineering
Units
continued next page
Advertisement
Table of Contents
