Omega DP41-S User Manual page 4

Table of Contents
8.5
SECTION 9 METER FUNCTION MENUS
9.1
9.2
9.2.1
9.2.2
9.2.3
9.2.4
9.2.5
9.2.6
9.2.7
9.2.8
9.2.9
9.2.10
9.2.11
9.2.12
9.2.13
9.2.14
9.2.15
9.2.16
9.2.17
9.2.18
9.2.19
9.2.20
9.2.21
9.2.22
9.2.23
9.2.24
SECTION 10 SETPOINTS/ALARMS
10.1
10.2
10.3
10.4
10.5
10.6
10.7
10.8
10.9
10.10
10.11
ii
Potentiometer Input, programming the meter
for a desired Display ............................................................8-40
Individual Lockout Information ...............................................9-1
Meter Function Menus ...........................................................9-7
Input.......................................................................................9-7
RDG.CNF (Reading Configuration) .......................................9-7
RDG SC (Reading Scale) and RDG OF (Reading Offset).....9-9
IN CNF (Input Configuration) ...............................................9-11
IN.SC.OF (Input Scale and Offset) ......................................9-12
DEC PT (Decimal Point) ......................................................9-14
CNT BY (Count By) .............................................................9-15
FIL.CNF (Filter Configuration) .............................................9-16
FIL TI (Filter Time Constant) ................................................9-17
SP CNF (Setpoints 1 & 2 Configuration) .............................9-18
AL CNF (Alarm Configuration).............................................9-19
AL FNC (Alarm Function) ....................................................9-21
AL RDG (Alarm Readings) ..................................................9-22
SP DB (Setpoint Deadband)................................................9-23
AL DB (Alarm Deadband) ....................................................9-23
OUT.CNF (Output Configuration).........................................9-24
OT.SC.OF (Output Scale and Offset) ..................................9-25
BAUD (Baud Rate) ..............................................................9-26
SERCNF (Serial Communication Configuration) .................9-27
ADDRESS (Multipoint Communications Device Address)...9-28
DAT FT (Data Format) .........................................................9-28
BUS FT (Bus Format) ..........................................................9-30
SERCNT (Serial Count).......................................................9-31
Analog Output Calibration Numbers ....................................9-32
Features overview ...............................................................10-1
Unlocking the Features........................................................10-3
Selecting "SP CNF" Setpoint Configuration Features..........10-3
Deviation Function for Alarms..............................................10-4
Selecting "AL CNF" Alarm Configuration Features ..............10-5
Selecting "AL FNC" Alarm Configuration Features ..............10-7
"AL RDG": Alarm Readings-Select Delay in Alarm Action ...10-8
"SP DB": Select "SP 1"and "SP 2" Deadband (Hysteresis) .10-8
"AL DB": Select Alarm 1 ("SP 3")
and Alarm 2 ("SP 4") Deadband ( Hysteresis) .....................10-8
"OUT.CNF": Control Flashing of the Display........................10-9
Entering Setpoint Levels (in Run Mode) ..............................10-9