Figure 5-2 Board Assembly Removing/Installing Detail - Omega DP41-S User Manual

5. Using Figure 5-2 as a guide, bend the side-panel detents on the case
outward and pull the board assembly out of the case by the mounting
screw stem.
NOTE: From this point forward, these 5 steps are referred to as "Reveal the
Note
main board".
PRODUCT
IDENTIFICATION
LABEL
SIGNAL INPUT
JUMPER LABEL
Figure 5-2. Board Assembly Removing/Installing Detail
The meter is now disassembled to the point where you can check and
configure jumpers and install boards.
REINSERTING THE MAIN BOARD ASSEMBLY INTO THE CASE
Reinsert the Main Board into the case once jumpers and optional boards
have been configured and installed.
Spread the side-panel detents of the case, and carefully slide the main
board all the way in.
MAIN BOARD ASSY
BEND DETENTS OUTWARD
TO INSTALL MAIN BOARD
CASE
Setup
MOUNTING
SCREW
STEM
5
5-3