Table of Contents
Advertisement
Target IDs can be divided into Logical Unit Numbers (LUNs) to extend the
number of available addresses. The default TID settings for both SCSI channels
is 0. This setting is adequate for most WebPAM and RAID subsystem
configurations. If an address conflict occurs, you might have to change the TID
setting.
You must have Creation Rights to access this function.
To access SCSI Target ID settings:
1.
Click on the Subsystem
2.
Click on the VTrak
3.
Click on the SCSI Management
4.
Click on the TID Settings tab.
To make settings:
1.
Select the SCSI Target IDs you want to use on SCSI Channel 1.
2.
Select the SCSI Target IDs you want to use on SCSI Channel 2.
3.
Click the Submit button when you are done.
Conflicting ID numbers can prevent WebPAM from connecting to
the RAID subsystem and/or cause the SCSI HBA BIOS not to
recognize the Logical Drives. Promise offers a sufficient quantity
of TIDs and LUNs to avoid any conflict problems.
The quantity and ID number of Target IDs you select depends in
part upon how many logical drives you plan to create, how your
Host PC and RAID subsystem are connected, and how many
addresses are on the SCSI bus.
Step 10: VTrak Setup with WebPAM PRO
icon in Tree View.
icon.
icon.
Caution
Note
43
Advertisement
Table of Contents
