Table of Contents
Advertisement
STEP 1
Attach front stabilizer (2) and rear stabilizer (4) to
main frame (1) by fixing Carriage bolt(6), Arc wash-
ers(8) and cap nut (9)
STEP 2
Thread the right pedal (11R)which marked "R" onto
the right side of the crank(10) , then circumvolved
easilly and tighten; do the same way to thread the
left pedal (11L) which marked "L" onto the left side of
the crank (10), then circumvolve anticlockwise and
tighten.
STEP 3
Put the handlebar post (7) through the end cap(10),
connect the Extension Sensor Wire (15) onto the
Sensor Wire (13) and connect the Tension Control
Cable(12) onto the cable of the Tension Control (14)
which is threaded the upright post(17).
Lock the upright post (17)onto the mainframe(1)with
the Arc Washer(8) and the screw(16),
A
B
Support
métallique
14
6
12
9
6
C
Support
14
6
métallique
12
9
Advertisement
Table of Contents
