3
3.10.3
32
Installation
1
Figure 3.6 Connecting block (connections 1 to 15 explained in
By way of preparation, first disassemble the protective cap from the control
column:
1. Undo the 4 screws a and remove the protective cap 2 from the electrical
section. The connecting block 3 is now visible.
n
Remark
Consult
'A.2 Electrical diagram SCE'
components.
Mains voltage
The appliance is supplied without a supply cable and main switch.
n
Remark
To supply the appliance with voltage, the appliance has to be connected to
the mains voltage by means of a permanent electrical connection. A two-
terminal main switch with a contact gap of at least 3 mm must be fitted
between this fixed connection and the appliance. The supply cable must
incorporate cores measuring a minimum of 3 x 1.0 mm
1. Feed the supply cable through the metric pull relief on the top of the control
column.
A
), phase (L
2. Connect earth (
1 to 3 in the connecting block as set out in
3. Tighten the pull relief so that the cable is jammed.
4. If you do not need to make any more connections, then fit the protective cap
on the control column.
15
before connecting any electrical
) and neutral (N) on the supply cable to points
1
Table
3.8.
Instruction Manual SCE
is
c
a
b
IMD-0134
Table
3.8)
2
.