Putting Into And Out Of Operation; Introduction; Putting Into Operation; Putting Out Of Operation - State Water Heaters SCE 80-115 Installation, User And Service Manual

gis gis
7
7.1

Introduction

7.2 Putting into
operation
7.3 Putting out of
operation
7.3.1
7.3.2
7.3.3
Release R.1.0 Uk
Putting into and out of
operation
The following will be examined in turn in this chapter:
• Putting into operation;
• Putting out of operation;
• The appliance's warm-up
You put the appliance into operation as follows:
1. Fill the appliance. See chapter
2. Open the gas valve (see
3. Switch on the voltage to the appliance using the main switch between the
appliance and the power supply.
4. Set the appliance using the I/0/II switch on the control panel in the ON mode
('I' position) or in the weekly program mode ('II' position). See paragraph '6.2
operating states'.
5. Set the desired water temperature using the control thermostat. See
paragraph'5.5 Control thermostat'
If there is a heat demand, the warm-up cycle will be run. See paragraph
appliance's warm-up cycle'.
You can:
• Put appliance out of operation for a short period ("OFF
• Disconnecting the appliance from the
• Putting the appliance out of operation for a long prideful

Put appliance out of operation for a short period ("OFF mode")

To put the appliance out of operation for a short period, you need to switch on
frost protection. See also paragraph
Using frost protection you prevent the water from freezing in the appliance. You
activate frost protection by switching the I/0/II- switch on the control panel to the
0 position.

Disconnecting the appliance from the mains

You are not permitted to just disconnect the appliance from the mains. The
correct procedure is as follows:
1. Put the appliance out of operation by setting the I/0/II switch to the 0
position.
2. Switch off the power to the appliance by setting the main switch between the
appliance and the mains power supply to position 0.

Putting the appliance out of operation for a long prideful time

Drain the appliance if you are putting it out of operation for a lengthy period of
time. Proceed as set out in paragraph
cycle.
'4 Filling and draining'.
'Figure 4.1 Connection diagrams').
mains.
'2.3 Warm-up cycle of the appliance'
'4.3 Draining the
Introduction
'7.4 The
mode").
time.
appliance'.
53