Introduction; Conversion To Another Gas Category Sce 80-115 To 65-400 Incl - State Water Heaters SCE 80-115 Installation, User And Service Manual

3
3.11.1
Legend
a cover plate
b blocking strip
c injector with stamped figures
3.11.2
Remember
The burner may be
hot.
34
Installation

Introduction

If the appliance has to operate on some gas family (LP-gas or natural gas)
other than the category of gas for which the appliance has been set up as
standard, the appliance should be adapted using a special conversion kit.
2
Figure 3.7 Replacing injectors
The conversion of the SCE 65-500 differs from the other SCE-appliances. The
conversion procedures are described in the paragraphs:
•

'3.11.2 Conversion to another gas category SCE 80-115 to 65-400 incl.'

• '3.11.3 Convert to another category of gas SCE
Conversion to another gas category SCE 80-115 to 65-400 incl.
(80-115, 80-140, 80-180, 95-199, 95-260, 70-360, 65-400)
1. Disconnect the appliance from the mains. See paragraph
'7.3.2 Disconnecting the appliance from the
2. Switch off the gas supply.
3. Screw the cover plate a from the burner support.
4. Use a suitable tool to remove the blocking strips b. The blocking strips in
fact have sharp edges.
Completely pull off the blocking strips.
n Remark
The radiation shield / the condensation tray can be temporarily loosened to
simplify assembly of the burner.
1
65-500'.
mains'.
Instruction Manual SCE
is
3
IMD-0126