Introduction; Fitting The Draught Diverter - State Water Heaters SCE 80-115 Installation, User And Service Manual

is
3.9.1
3.9.2
Legend
a draught diverter
b fastening screws
c flue gas outlet pipe
Release R.1.0 Uk

Introduction

When connecting the appliance to the flue gas outlet duct one must use the
draught diverter a that is supplied. The standard flue gas thermostat and
sensor that are supplied should be fitted in the

Fitting the draught diverter

The draught diverter ais fastened using two fastening screws b. The assembly
procedure is as follows:
> 0,5 m
a
b
Figure 3.4 Fitting the draught diverter
1. Place the draught diverter on the appliance and mark the drill holes.
Remove the draught diverter from the appliance.
n Remark
The position of the holes already made for the flue gas cut-out sensor must
be taken into account. The holes must be roughly in line with the flue gas
thermostat bracket.
2. Now drill two holes into the top of the appliance (3.2 mm drill bit).
3. Using the fastening screws, fix the draft limiting device to the appliance.
4. Fit to the opening of the draft limiting device a vertical flue gas outlet
pipe flue gas outlet pipe c measuring at least 0.5 metres and then fit the rest
of the flue gas outlet materials in accordance with the current regulations.
See paragraph '1.3 Regulations'.
n
Remark
Use flue gas outlet parts that comply with the regulations. See paragraph
'1.3 Regulations'.
n
Remark
Make sure that the flue gas outlet is fitted in a discharge area in which it is
is permitted for the relevant category of appliance.
Flue gas outlet
draught diverter.
c
IMD-0148
29