Table of Contents
Advertisement
When the LED is flashing, there is traffic on the network to
which the 5-Speed NBASE-T Network Controller Card is
connected
Link Speed Indicator:
When the LED is lit orange, a 10GBase-T link is established
When the LED is lit green, a 5GBase-T/2.5GBase-T/1000Base-T
link is established
When the LED is off, a 100Base-T link is established
2.2 Hardware Installation
1.
Turn off the power to your computer.
2.
Unplug the power cord and remove your computer's cover.
3.
Remove the slot bracket from an available PCIe slot.
4.
To install the card, carefully align the card's bus connector with
the selected PCIe slot on the motherboard. Push the board down
firmly.
5.
Replace the slot bracket's holding screw to secure the card.
6.
Secure the computer cover and reconnect the power cord.
Page 7
Advertisement
Table of Contents
