Table of Contents
Advertisement
2.4GHz Wireless Lite-N PCI-E Adapter
Chapter 2 Installation Guide
2.1 Hardware Installation
To install the adapter, follow these steps listed below:
1.
Turn off your desktop PC and disconnect the power.
2.
Remove your PC case and locate an available PCI-E slot on the motherboard.
Remove the metal slot cover on the back of the PC. Check with your computer
manufacturer for instructions if needed.
3.
Slide the PCI-E Adapter into the PCI-E slot. Make sure that all of its pins are touching
the slot's contacts. Once the adapter is firmly in place, secure its fastening tab to your
PC's chassis with a mounting screw. Then, close your PC case.
4.
Reconnect your PC's power and turn on your desktop PC.
2.2 Software Installation
2.2.1 Overview
The Adapter's Setup Wizard will guide you through the Installation procedure for Windows
2000/ XP/ Vista/ 7. The Setup Wizard will install the Wireless Lite-N Client Utility and
drivers.
When you install the hardware before installing the software, the system will prompt
"Found New Hardware Wizard", click Cancel, and run the Setup Wizard program on the
CD-ROM.
The Setup steps for Windows 2000/ XP/ Vista/ 7 are very similar. The following setup
steps are for Windows XP/Vista/7.
2.2.2 Software Installation for Windows XP
1.
Insert the Resource CD into your CD-ROM drive, and open the folder named
RNX-N150PCe. Double-click Setup.exe in the proper folder to start the installation,
then the following screen for preparing setup will appear.
RNX-N150PCe
8
User Manual
Advertisement
Table of Contents
