Output Ip Address; Input Parameter - Triax CCE 210 Assembly Instructions Manual

Output IP address

In this menu you set the output IP address for the selected transport stream.
• Press the
• Using the
As by setting IP SPTS two transport streams are provided, the settings "MODE/
PORT", "PKTS/FEC" and "OUT-IP" must be done two times (IP 1 and IP 2).
After the settings for IP 1 button
Allocate different IP addresses to the transport streams!
• Press the
• Press the

Input parameter

In this menu you select the input, you would like to set the input parameters in
the submenus (AV 1 or AV 2).
• Using the
• Press the
IP 1/2
227. 40.
buttons to select the digit of the IP address to be set.
buttons set the IP address wished.
button.
—> Return to the main menu "Output signal path"
button.
—> The "Input parameter" – "INPUT" main menu is activated.
—> If you do not want to do input settings, press the
"ASI station filter" – "ASI" main menu is activated (page 28)
Bx 2 INPUT
AV 1
buttons select the corresponding input.
button.
—> The "Data rate of the video signal " – "BITRATE" submenu is acti-
vated.
OUT-IP
50. 60
will take you to the settings for IP 2.
Bx 2
=> AV 2
- 23 -
button. The
INPUT
=>
CCE 210