Table of Contents
Advertisement
Part names and
functions
n Sensor unit
A
E
B
C
Sensor unit cover
M
N
Used to confirm the status of the
sensor or register the sensor to
the hub.
LED indicator
Magnet unit cover
" " marks
Used to align the sensor and the
magnet unit when installing them
(page 13).
Helpline Tel. No.: U.K. 0330 3331112 Ireland 01 4475228
n Magnet unit
D
E
LED indicator
You can press M
LED indicator to confirm the sensor's
status.
Indicator
Status
Green, lit
Window/door is closed
Red, lit
Window/door is open
Red,
Sensor is out of range
blinking
of the hub
Green,
Registration mode
blinking
(You pressed and held
M
Off
No battery power
Note:
R The LED indicator does not indicate
sensor status if the sensor has not
been registered (page 11).
Setup overview
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Insert the battery
The window/door sensor is battery
powered.
3
Registration
Required only if the window/door
sensor was purchased separately
(i.e., not as part of a bundle).
4
Confirm the installation area
Read the information in this
document to confirm that the
Setup
N and check the
N)
9
Advertisement
Table of Contents
