Table of Contents
Advertisement
Setup
Part names and
functions
Microphone
LED indicator
MHIGHN/MLOWN
Used to change the sensor
sensitivity (page 14).
Rear cover
M
Used to confirm the status of the
sensor or register the sensor to
the hub.
About the LED
indicator
You can press M
LED indicator to confirm the sensor's
status.
8
HNS104_(en_en)_1120_ver.010.pdf
A
B
C
E
N
N and check the
For assistance, please visit www.panasonic.com/support
8
Indicator
Status
Green, lit
No glass break
detected
Red, lit
Glass break was
detected
Red,
Sensor is out of range
blinking
of the hub
Green,
Registration mode
blinking
(You pressed and held
M
Off
No battery power
Note:
R The LED indicator does not indicate
sensor status if the sensor has not
D
been registered (page 9).
Setup overview
1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Insert the batteries
The sensor is battery powered.
3
Registration
Required only if the sensor was
purchased separately (i.e., not as
part of a bundle).
4
Confirm the installation area
Read the information in this
document to confirm that the
desired installation area is suitable
to proper operation.
5
Installation
Install the sensor in the desired
location.
N)
2014/11/19
19:59:09
Advertisement
Table of Contents
