Table of Contents
Advertisement
Registering the
window/door sensor
This procedure is not required for
devices that were included as part of
a bundle.
Before you can use the window/door
sensor, it must be registered to the hub.
If you purchased devices separately
(i.e., not as part of a bundle), you must
register each device to the hub.
You can register each device by using
the registration buttons or the [Home
Network] app.
Using registration buttons
1
Hub:
Press and hold M
DEVICEN until the LED indicator
blinks in green.
2
Window/door sensor:
Remove the sensor unit cover and
press and hold M
LED indicator blinks in green
(page 9).
R When registration is complete,
the hub sounds one long beep.
Note:
R To cancel without registering the
sensor, press M
on the sensor again.
R If registration fails, the hub sounds
several short beeps.
Using the app
When you register the window/door
sensor by using the [Home Network]
app, you can assign a name to your
Helpline Tel. No.: U.K. 0330 3331112 Ireland 01 4475228
OTHER
N until the
N on the hub and
devices and group them by location.
For more information, refer to the
User's Guide (page 19).
Changing the sensor
type
You can select whether a window/door
sensor functions as a window sensor or
as a door sensor. For more
information, refer to the User's Guide
(page 19).
Setup
11
Advertisement
Table of Contents
