Setup; Part Names And Functions; Led Indicator; Setup Overview - Panasonic KX-HNA101C Installation Manual

Setup

Part names and
functions
Power plug
M
Used when registering the smart
plug to the hub.
Power outlet
M N (on/off)

LED indicator

Turns the connected device on
and off. Also serves as the LED
indicator.
LED indicator
You can use the LED indicator to
confirm the smart plug's status.
Indicator
Off
Green, lit
Green,
blinking
6
HNA101C̲(en̲en)̲0916̲ver.022.pdf 6
A
B
N
Status
No power, smart
plug is off, or LED
indicator is turned
off *1
Smart plug is on
Registration mode
For assistance, visit www.panasonic.ca/english/support
Indicator
Red, blinking
Red, blinking
quickly
C
*1 You can configure the smart plug
so that its LED indicator does not
light during normal operation. For
more information, refer to the User'
s Guide (page 9).
*2 In this case, the smart plug will
D
turn off automatically. To turn the
smart plug on again, disconnect it
from the power outlet, disconnect
the connected electric device, and
then connect the smart plug to the
power outlet.

Setup overview

1
Initial setup
Make sure you can access the
system using your mobile device.
For details, refer to the System
Setup Guide included with your
hub.
2
Connection
Connect the smart plug to the
power outlet and connect the
desired electric device to the smart
plug.
3
Registration
Required only if the smart plug
was purchased separately (i.e.,
not as part of a bundle).
4
Confirm the usage area
*1
Read the information in this
document to confirm that the
Status
Smart plug is out of
range of the hub
Connected electric
device is drawing
too much current or
wattage *2
2014/09/16 20:47:46