Table of Contents
Advertisement
Connect Cables
1
Flange on rear of outer left slide rail
2
CMA retaining bracket
3
Flange on rear of right mounting bracket
4
Flange on rear of outer right slide rail
Connect Cables
This section describes how to connect your Cisco SNS-3415 or Cisco SNS-3495 appliance to the network
and the appliance console.
•
•
•
•
Attach cables (such as keyboard, monitor cables, if required) to the rear of the server. Route the cables properly
and use the cable straps to secure the cables to the slide rails. See the
Back Panel View , on page 6
Connect the Network Interface
Warning: Do not work on the system or connect or disconnect cables during periods of lightning activity.
Warning
Statement 1001
This section describes how to connect the Cisco SNS-3415 or Cisco SNS-3495 appliance Ethernet port.
The Ethernet connector supports Serial over LAN (SOL) cables. The RJ-45 port supports standard
straight-through and crossover Category 5 unshielded twisted-pair (UTP) cables. Cisco does not supply
Category 5 UTP cables; these cables are available commercially.
Cisco SNS-3400 Series Appliance Hardware Installation Guide
24
Connect the Network Interface, on page 24
Connect the Console, on page 25
Connect the Keyboard and Video Monitor, on page 25
Cable Management, on page 26
for reference on the rear view of the appliance.
Install the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances
5
Inner CMA arm attachment clip
6
"UP" orientation marking
7
Outer CMA arm attachment clip
Cisco SNS 3415 or SNS 3495 Appliance
Hide quick links:
Advertisement
Table of Contents
