Ct1 Trunk Card Cables And Pinouts; Ce1 Trunk Card Cables And Pinouts - Cisco AS5800 Manual

The ports labeled "Network Clock," "10BaseT," "Dial Shelf
Interconnect," "Console," and "Alarms" are safety extra­low voltage
(SELV) circuits. SELV circuits should only be connected to other SELV
circuits. Because the E1/T1 circuits are treated like telephone­network
voltage, avoid connecting the SELV circuit to the telephone network
voltage (TNV) circuits.
CT1 Trunk Card Cables and Pinouts
One interface cables is available from Cisco Systems for connecting
the CT1 card ports; the cable is described in .
Table 5
Cable Description Product Number
RJ­45 to Bare, 100­ohm CAB­T1­RJ45BARE
CT1 Interface Cables
The shows the CT1 interface cable, and describes the pinouts for the
CT1 interface cable.
Figure 7 RJ­45­to­Bare Wire Interface Cable
Table 6
RJ­45
Pin Signal Description
Shield Ground Braid
J1­1 RX Tip Twisted Pair
#1
J1­2 RX Ring Twisted Pair
#1
J1­3 RX
Shield
J1­4 TX Tip Twisted Pair
#2
J1­5 TX Ring Twisted Pair
#2
J1­6 TX
Shield
RJ­45­to­Bare Cable Pinouts
CE1 Trunk Card Cables and Pinouts
Seven interface cables are available from Cisco Systems for
connecting the CE1 card ports; these cables and their product
numbers are listed in .
Table 7
Cable Description
RJ­45 to RJ­45, 120­ohm
RJ­45 to DB­15, 120­ohm
RJ­45 to DB­15 Null, 120­ohm CAB­E1­RJ45DB15N
RJ­45 to BNC, 75­ohm
RJ­45 to Twinax, 75­ohm
RJ­45 to RJ­45 TE, 120­ohm
RJ­45 to RJ­45 NT, 120­ohm
CE1 Interface Cables
The following figures and tables illustrate and describe the pinouts for
each CE1 interface cable:
Direction Bare
<— WIRE­
1
<— WIRE­
2
—> WIRE­
3
—> WIRE­
4
Product Number
CAB­E1­RJ45RJ45
CAB­E1­RJ45DB15
CAB­E1­RJ45BNC
CAB­E1­RJ45TWIN
CAB­E1­RJ45TE
CAB­E1­RJ45NT