Table of Contents
Advertisement
SONIC-ANEMO-DZP
5. Commissioning
For a correct start, the PV module must supply at the minimum energy comparable to 50 W/m² solar energy.
The battery is disconnected for delivery.
Disconnected battery
It is recommended to complete the wiring of your installation before connecting the battery.
Then, insert the connectors inside the tube and plug the cap in place.
After one minute of initialisation and with enough sun exposure, your SONIC-ANEMO-DZP is ready to operate.
6. Maintenance
The SONIC-ANEMO-DZP does not require particular maintenance. Wipe eventually the solar module from time
to time.
Warning: Do not use alcohol base cleaning products. Use a clean soft cloth, clear water or a neutral
cleaning product.
7. Replacing the battery
Choose a clean and dry location to change the battery.
a)- Disconnect the RJ11 from the SIM.
b)- Dismount the SONIC-ANEMO-DZP.
c)- Open the tube.
d)- Pull the battery's wires.
e)- Disconnect the battery.
f)- Spot the North mark on the battery's box.
g)- Unscrew the 3 screws of the battery's box:
h)- Slide the tube along the cable to access the battery.
i)- Pull the battery out with the wires and connectors.
j)-Insert the wires and connectors of the new battery until they come out of the other side of the tube.
k)- Put the new battery in place.
l)- Slide the tube back to the slot while taking care of the North mark previously identified.
m)- Tighten the 3 screws.
n)- Connect the battery.
© LCJ Capteurs 2016 – All rights reserved.
Connected battery
Page 6
Advertisement
Table of Contents
