Nvm Reset - Pyronix sterling 10 Installation Manual
Control panel with remote keypads
Hide thumbs
Also See for sterling 10:
- Installation instructions manual (34 pages) ,
- User manual (24 pages) ,
- Installation instructions (2 pages)
Table of Contents
Advertisement
Sterling 10 Installation Manual
1.1 NVM Reset
To reset the panel back to factory defaults, follow the procedure below.
1. Open the panel, and disconnect the mains power (by removing the fuse from the terminal block) and the
battery.
2. Locate the pins marked "NVM RESET", and short them together using a length of wire or a jumper.
3. Re-apply the mains power.
4. After the panel has finished its start-up sequence, remove the short on the NVM reset pins, and connect
the battery.
The panel is now reset to factory defaults.
If the above procedure does not reset the panel, then "Engineer Code & NVM Reset" has been enabled. Follow
the procedure described on page 22 (Icon) or page 32 (LCD) in order to reset the system
Page 2
RINS1413-1
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the sterling 10 and is the answer not in the manual?