Siemens 9410RC User Manual page 87

Maintenance
Loading remote display firmware using FTP
7EN05-0336-01
• Your meter's option module firmware upgrade (.SI9) file(s). You can download
upgrade files from www.usa.siemens.com/pds.
• The option module connected to your meter, and have access to your meter's
internal FTP site.
Your meter's digital and analog outputs may change state during a firmware upgrade.
Option modules are offline during an option module firmware upgrade; they will not
communicate to the meter and the outputs may change state during the upgrade
process.
UNINTENDED OPERATION
Failure to follow these instructions can result in death, serious injury, or
equipment damage.
Do not use this device for critical control or protection applications where human or
equipment safety relies on the operation of the control circuit.
NOTE: If your meter's option module loses power during firmware upload, the option
module will revert to its original firmware and you will have to reload the firmware file.
1. Connect to your meter's internal FTP site. Open the remote display upgrade
(rmdUpg) folder.
2. Drag the remote display firmware file into the remote display upgrade folder.
The file is immediately transferred to the remote display, and is not stored on the
meter.
3. Watch your meter's display to confirm the firmware upgrade is taking place.
4. Review the remote display firmware upgrade details stored in the meter's event log
to confirm that the upload was successful.
You can upload firmware to your meter's remote display by loading the firmware
upgrade file onto your meter's internal FTP site.
You must have:
• Your meter's remote display firmware upgrade (.BIN) file. You can download
upgrade files from www.usa.siemens.com/pds.
• The remote display connected to your meter, and have access to your meter's
internal FTP site.
1. Connect to your meter's internal FTP site.
2. Open the remote display upgrade (rmdUpg) folder.
3. Drag the remote display firmware file into the remote display upgrade folder.
The file is immediately transferred to the remote display, and is not stored on the
meter.
4. Watch your meter's display to confirm the firmware upgrade is taking place.
WARNING
9410 series
87