Dodge grand caravan 2011 Owner's Manual page 148

JOBNAME: cims CHRY OM French PAGE: 148 SESS: 4 OUTPUT: Tue Nov 2 10:27:14 2010 SUM: 35F7C92D
/chry_pdm/chrysler/owners/car/og
UNDERSTANDING THE FEATURES OF YOUR VEHICLE
will now occur for the trained device (i.e.,
garage door opener, gate operator, secu-
rity system, entry door lock, home/office
lighting, etc.,). The handheld transmitter of
the device may also be used at any time.
Reprogramming A Single HomeLink
Button
To reprogram a channel that has been
previously trained, follow these steps:
1. Turn the ignition switch to the ON/RUN
position.
2. Press and hold the desired HomeLink
button until the indicator light begins to
flash after 20 seconds. Do not release the
button.
3. Without releasing the button, pro-
ceed with
Step 2 and follow all remaining steps.
148
Security
It is advised to erase all channels before
you sell or turn in your vehicle.
To do this, press and hold the two outside
buttons for 20 seconds until the red indi-
cator flashes. Note that all channels will be
erased. Individual channels cannot be
erased.
The HomeLink Universal Transceiver is
disabled when the Vehicle Security Alarm
is active.
Troubleshooting Tips
If you are having trouble programming
HomeLink , here are some of the most
common solutions:
• Replace the battery in the original trans-
Programming HomeLink mitter.
• Press the LEARN button on the Garage
Door Opener to complete the training
for a Rolling Code.
• Did you unplug the device for training,
and remember to plug it back in?
If you have any problems, or require as-
sistance, please call toll-free 1–800–355–
3515 or, on the Internet
www.HomeLink.com for information or as-
sistance.
General Information
This device complies with FCC rules Part
15 and Industry Canada RSS-210. Opera-
tion is subject to the following two condi-
tions:
1. This device may not cause harmful
interference.
at