Configuring A Port As A Simulated Member Host; Enabling Fast-Leave Processing - HPE FlexNetwork 5130 EI Series Configuration Manual

The static member port does not respond to MLD queries. When you complete or cancel this
configuration, the port does not send an unsolicited report or done message.
•
Static router port—When you configure a port as a static router port for an IPv6 multicast
group, all IPv6 multicast data for the group received on the port will be forwarded.
Static member ports and static router ports never age out. To remove such a port, use the undo
mld-snooping static-group or undo mld-snooping static-router-port command.
To configure static ports:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
3. Configure the port as a static
port.

Configuring a port as a simulated member host

When a port is configured as a simulated member host, it is equivalent to an independent host in the
following ways:
•
It sends an unsolicited MLD report when you complete the configuration.
•
It responds to MLD general queries with MLD reports.
•
It sends an MLD done message when you remove the configuration.
The version of MLD running on the simulated member host is the same as the version of MLD
snooping running on the port. The port ages out in the same ways as a dynamic member port.
To configure a port as a simulated member host:
Step
1. Enter system view.
2. Enter Layer 2 Ethernet
interface view or Layer 2
aggregate interface view.
3. Configure the port as a
simulated member host.

Enabling fast-leave processing

This feature enables the switch to immediately remove a port from the forwarding entry for an IPv6
multicast group when the port receives a done message.
Command
system-view
interface interface-type
interface-number
•
Configure the port as a static
member port:
mld-snooping static-group
ipv6-group-address
[ source-ip
ipv6-source-address ] vlan
vlan-id
•
Configure the port as a static
router port:
mld-snooping
static-router-port vlan
vlan-id
Command
system-view
interface interface-type
interface-number
mld-snooping host-join
ipv6-group-address [ source-ip
ipv6-source-address ] vlan vlan-id
61
Remarks
N/A
N/A
By default, a port is not a static
member port or a static router
port.
Remarks
N/A
N/A
By default, the port is not a
simulated member host.