Configuring Igmp Snooping Port Features; Setting Aging Timers For Dynamic Ports - HPE FlexNetwork 5130 EI Series Configuration Manual

To set the maximum number of IGMP snooping forwarding entries:
Step
1. Enter system view.
2. Enter IGMP-snooping view.
3. Set the maximum number of
IGMP snooping forwarding
entries.

Configuring IGMP snooping port features

Before you configure IGMP snooping port features, complete the following tasks:
•
Enable IGMP snooping for the VLAN.
•
Determine the aging timer for dynamic router ports.
•
Determine the aging timer for dynamic member ports.
•
Determine the addresses of the multicast group and multicast source.

Setting aging timers for dynamic ports

When you set aging timers for dynamic ports, follow these guidelines:
•
If the memberships of multicast groups frequently change, you can set a relatively small value
for the aging timer of the dynamic member ports. If the memberships of multicast groups rarely
change, you can set a relatively large value.
•
If a dynamic router port receives a PIMv2 hello message, the aging timer value for the port is
specified by the hello message. In this case, the router-aging-time or igmp-snooping
router-aging-time command does not take effect on the port.
•
You can set the timers globally for all VLANs in IGMP-snooping view or for a VLAN in VLAN
view. For a VLAN, the VLAN-specific configuration takes priority over the global configuration.
Setting the aging timers for dynamic ports globally
Step
4. Enter system view.
5. Enter IGMP-snooping view.
6. Set the aging timer for dynamic
router ports globally.
7. Set the global aging timer for
dynamic member ports globally.
Setting the aging timers for dynamic ports in a VLAN
Step
1. Enter system view.
2. Enter VLAN view.
3. Set the aging timer for
dynamic router ports in the
VLAN.
4. Set the aging timer for
Command
system-view
igmp-snooping
entry-limit limit
Command
system-view
igmp-snooping
router-aging-time interval
host-aging-time interval
Command
system-view
vlan vlan-id
igmp-snooping
router-aging-time interval
igmp-snooping host-aging-time
18
Remarks
N/A
N/A
The default setting is
4294967295.
Remarks
N/A
N/A
The default setting is 260
seconds.
The default setting is 260
seconds.
Remarks
N/A
N/A
The default setting is 260
seconds.
The default setting is 260