SETTING UP THE PRINTER
Release The Printing Head
When the printer is token out from the foam box firstly, the printing head is locked. So you should release the
work platform before you using the printer.
1.
When you open the top door, you will find that nozzle is
locked in position by four screws. Unscrew the outside
two locks as shown in the picture.
2.
After the four lock blocks removed, please install the
motor on top of the extruder and you can use the printer.
14
Figure 3.6
Figure 3.7
www.intamsys.com
Need help?
Do you have a question about the FUNMAT HT and is the answer not in the manual?