Advertisement
Quick Links
Advertisement
Related Manuals for Intamsys FUNMAT PRO 310
Summary of Contents for Intamsys FUNMAT PRO 310
- Page 1 FUNMAT PRO 310 Quick Start Guide...
-
Page 2: Product Appearance
1. Product Appearance Top cover Feeding entrance USB connection Operation interface Switch button Power interface Watching window Independent filament Front door sensor Build plate Electromagnetic lock Top air outlet Top door handle Back air outlet Left side plate Back side plate Outer cover screw... -
Page 3: Material Selection
SP3030 SP3050 materials INTAMSYS recommended model material and support material fit table Note: Detailed printing process parameters for filaments can be found in the "FUNMAT PRO 310 Printing Process Guide". 3. Printer Preparation Unpacking 1) Remove the fixed straps from the packaging box and take off the wooden board on top of it;... - Page 4 and material boxes from below. unscrew two screws that fixate X- axis guide block, then remove X- axis fixing block. 9) Repeat step 8 to remove Y-axis fixing block fixed on front side panel. 10) Turn off power, push printhead out enough space by moving it 12) Rotate the pressure rods on leftward, repeat same method to...
- Page 5 Database" button will display the printer is inconsistent with click the left or right spool icon INTAMSYS materials and user- the material settings in the G- to select the extruder to be defined materials. Materials that code print file, the system will loaded with materials.
- Page 6 Auto-leveling Cautions: During the installation of the printing build plate before leveling, it shall be correctly adsorbed on the hotbed along the guide grooves on both sides of the platform base plate; Clean the residual materials on the nozzle tip before leveling; ...
- Page 7 "INTAMSUITE User Manual". Slicing software download address: https://www.intamsys.cn/software.html Note: After the G-code file is generated, it will prompt you to estimate the material weight required for printing the model. The printing wire should be greater than the estimated weight. If the amount of...
- Page 8 File import and print 2) Use the network transmission, 3) Select USB storage or local 1) Use USB storage (USB flash drive) to import. After copying enter the IP address of the printer storage; through the USB flash drive, in the address bar of the window insert it into the USB port on folder on the computer side, and the right side of the printer's...
- Page 9 6 Process after printing For model parts manufactured by FDM 3D printing, there may be significant lamination after printing; In addition, some model parts need to add support, which will lead to rough support parts; And there is deformation of the parts, resulting in differences between the printed solid model and its digital model.
- Page 10 11479 Valley View Road, Eden Prairie, MN 55344 Copyright ©2023 INTAMSYS Technology. All rights reserved. The information at hand is provided as available at the time of printing, INTAMSYS reserves the right to change any information without updating this publication.
Need help?
Do you have a question about the FUNMAT PRO 310 and is the answer not in the manual?
Questions and answers