Display (Operating Mode) - Endress+Hauser Proline Promag 55 Operating Instructions Manual

Operation
58
5.2.2

Display (operating mode)

The display area consists of three lines in all; this is where measured values are displayed, and/or
status variables (direction of flow, bar graph, etc.). You can change the assignment of display lines
to variables at will in order to customize the display to suit your needs and preferences ( see the
"Description of Device Functions" manual, BA00125D).
Multiplex mode:
A maximum of two different display variables can be assigned to each line. Variables multiplexed in
this way alternate every 10 seconds on the display.
Error messages:
Display and presentation of system / process errors  ä 62
TOT
Fig. 43: Typical display for normal operating mode (HOME position)
1 Main line shows main measured values, e.g. flow
2 Supplementary line shows supplementary measured or status variables, e.g. totalizer reading.
3 Information line shows additional information on measured or status variables,
e.g.bar graph display of the full scale value achieved by the mass flow
"Info icons" field shows additional information in the form of icons on the measured values displayed. See  ä 59
4
for a full list of the icons and their meanings.
5 "Measured values" field shows the current measured values.
6 "Unit of measure" field shows the units of measure and time defined for the current measured values.
4 5
+24.502
v
3
+1863.97
OK
v
–50 +50
Proline Promag 55 PROFIBUS DP/PA
6
x
1
y
y
x
2
%
3
A0004755
Endress+Hauser