Panasonic PT-RZ21K Operating Instructions Manual page 64

Chapter 3 Basic Operations — Switching on/off the projector
Initial setting (installation setting)
Set [FRONT/REAR] and [FLOOR/CEILING] in [PROJECTION METHOD] depending on the installation mode.
Refer to "Installation mode" (x page 36) for details.
After completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu →
[PROJECTION METHOD].
1) Press qw to switch the setting.
2) Press the <ENTER> button to proceed to the initial setting.
Initial setting (standby mode)
Set the operation mode during standby. The factory default setting is [NORMAL], which allows you to use the
network function during standby. To keep power consumption low during standby, set this item to [ECO]. After
completed the initial setting, you can change the setting from the [PROJECTOR SETUP] menu → [STANDBY
MODE].
1) Press qw to switch the setting.
2) Press the <ENTER> button to proceed to the initial setting.
Note
f The preceding initial setting screen is displayed when the projector is switched on for the first time after purchase. When the [PROJECTOR
SETUP] menu → [INITIALIZE] → [ALL USER DATA] is executed, the [STANDBY MODE] setting before execution is displayed.
64 - ENGLISH
INITIAL SETTING
PROJECTION METHOD
FRONT/REAR FRONT
FLOOR/CEILING AUTO
Change the projection method (FRONT/REAR,
FLOOR/CEILING) if the screen display is upside down
or inverted.
MENU SELECT CHANGE
SET
ENTER
INITIAL SETTING
NORMAL
STANDBY MODE
When set to ECO, network functions and SERIAL OUT
terminal, and some RS-232C commands are not
available during standby.
CHANGE
SET
ENTER
3/7
4/7