Specifications - Panasonic PT-RZ21K Operating Instructions Manual

Specifications

The specifications of the projector are as follows.
Power supply
Power consumption
Power consumption (during
standby)
Size
DLP chip Display system
Number of pixels
Lens
Light source
Light output
Center to corner zone ratio
*1
Contrast ratio
*1
Color system
Projected image size
Image aspect ratio
Projection method
Power cord length
Outer case
Outer color
Width
Dimensions Height
Depth
Weight
Noise level
*1
Operating
environment
temperature
Operating
environment
Operating
environment
humidity
Power supply
Operating range
Remote
control
Weight
Dimensions
*1 Measurement, measuring conditions, and method of notation all comply with ISO/IEC 21118:2012 international standards.
*2 The value of the light output at the center region of the projected image is extracted based on the light output measurement method defined by the
ISO/IEC 21118:2012 international standards.
*3 When a projection lens other than ET-D75LE95, ET-D75LE90 is used with the power supply voltage of AC 200 V.
*4 When the Zoom Lens (Model No.: ET‑D75LE8) is used, the projected image size for the maximum projection distance will be 1.78 m (70") to
15.24 m (600"). When the Fixed‑focus Lens (Model No.: ET‑D75LE95, ET‑D75LE90) is used, the projected image size for the maximum projection
distance will be 3.05 m (120") to 15.24 m (600").
*5 Average value. Weight varies for each product.
*6 The operating environment temperature should be between 0 °C (32 °F) and 45 °C (113 °F) if the projector is used at an altitude between 1 400 m
(4 593') and 4 200 m (13 780') above sea level.
*7 When the [PROJECTOR SETUP] menu → [OPERATION SETTING] → [OPERATING MODE] is set to [NORMAL] or [ECO], the light output may be
reduced to protect the projector.
f When using the projector at an altitude lower than 2 700 m (8 858') above sea level: 35 °C (95 °F)
f When using the projector at an altitude between 2 700 m (8 858') and 4 200 m (13 780') above sea level: 25 °C (77 °F)
Note
f The light output will decrease to approximately 1/2 when using the projector with AC 100 V to AC 120 V.
f The model numbers of accessories and optional accessories are subject to change without prior notice.
Chapter 7 Appendix — Specifications
100 V - 120 V / 200 V - 240 V ~ (100 V ‑ 120 V / 200 V ‑ 240 V alternating current), 50 Hz/60 Hz
940 W (9.6 A) / 1 510 W (7.7 A)
When [STANDBY MODE] is set to [ECO]: 0.3 W
When [STANDBY MODE] is set to [NORMAL]: 4 W
PT-RZ21K
PT-RS20K
DLP chip x 3, DLP projection system
PT-RZ21K
PT-RS20K
Optional
Laser x 2
20 000 lm , 21 000 lm (center)
*1 *3
(When [OPERATING MODE] is set to [NORMAL])
90 %
20 000:1 (when [DYNAMIC CONTRAST] is set to [3])
7 standards (NTSC/NTSC4.43/PAL/PAL‑N/PAL‑M/SECAM/PAL60)
1.78 m (70") to 25.40 m (1 000")
PT-RZ21K
PT-RS20K
[FRONT/CEILING], [FRONT/FLOOR], [REAR/CEILING], [REAR/FLOOR]
3.0 m (118‑1/8")
Molded plastic
Black
598 mm (23‑17/32") (excluding protrusions)
307 mm (12‑3/32") (with the feet at shortest position)
270 mm (10‑5/8") (excluding the feet and protrusion)
725 mm (28‑17/32") (excluding the protrusion)
Approx. 49.0 k] (108.0 lbs.)
*5
46 dB
0 °C (32 °F) to 50 °C (122 °F)
*6*7
10 % to 80 % (no condensation)
DC 3 V (AA/R6/LR6 battery x 2)
Within approx. 30 m (98'5") (when operated directly in front of signal receiver)
150 ] (5.3 ozs.) (including batteries)
Width: 47.5 mm (1‑7/8"), Height: 181.5 mm (7‑5/32"), Depth: 27.5 mm (1‑3/32")
24.4 mm (0.96") (aspect ratio 16:10)
24.1 mm (0.95") (aspect ratio 4:3)
2 304 000 pixels (1 920 x 1 200 dots)
1 470 000 pixels (1 400 x 1 050 dots)
*2 *3
*4
16:10
4:3
ENGLISH - 245