Panasonic PT-RZ21K Operating Instructions Manual page 140

[LENS INFORMATION SETTING]
Confirming the projection lens information
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Press as to select [LENS INFORMATION SETTING].
4) Press the <ENTER> button.
f The [LENS INFORMATION SETTING] screen is displayed.
[LENS ID]
[LENS NAME]
[LENS TYPE]
[LENS ZOOM TYPE]
Note
f [LENS INFORMATION SETTING] is not displayed when a projection lens without built-in EEPROM is attached.
Setting ID to the projection lens
Write the identification information unique to the projection lens into the EEPROM built in the projection lens. Set
ID if required.
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Press as to select [LENS INFORMATION SETTING].
4) Press the <ENTER> button.
f The [LENS INFORMATION SETTING] screen is displayed.
5) Press as to select [LENS ID].
6) Press qw to switch the item.
f The items will switch each time you press the button.
[ALL]
[1] - [255]
Note
f [LENS INFORMATION SETTING] is not displayed when a projection lens without built-in EEPROM is attached.
f If the standard DC motor unit installed in the Zoom Lens (Model No.: ET‑D75LE6, ET‑D75LE8, ET‑D75LE10, ET‑D75LE20, ET‑D75LE30,
ET‑D75LE40, etc.) is replaced with the stepping motor unit using the Stepping Motor Kit (Model No.: ET‑D75MKS10), the [LENS ID]
information is written into the EEPROM built in the stepping motor unit every time the [LENS ID] item is switched.
f [LENS ID] will not return to factory default setting even when the [PROJECTOR SETUP] menu → [INITIALIZE] → [ALL USER DATA] is
executed.
Setting name to the projection lens
A name for identifying individual projection lens can be written into the EEPROM built in the projection lens. Set
the name if required.
1) Press as to select [LENS].
2) Press the <ENTER> button.
f The [LENS] screen is displayed.
3) Press as to select [LENS INFORMATION SETTING].
140 - ENGLISH
Chapter 4 Settings — [PROJECTOR SETUP] menu
Displays the set ID.
Displays the set name.
Displays the set projection lens type.
Displays the drive method of the zoom motor.
Select this item when the ID number is not to be specified.
Select this item when the ID number is to be set.