Advanced Phone Features; Call Recording - Yealink SIP-T42G User Manual

In the following figure, the phone LCD screen shows an incoming call from 3606 on the
monitored line.
If your phone is locked and the type of the keypad lock is set to be Function Keys or All
Note
keys, you cannot use the Pickup, Dial, New Call and Cancel soft keys appear in the
figure above until unlocked.
When there is an active call on the IP phone, you can transfer the active call to the
monitored phone number directly by pressing the BLF key. The phone transfers the
active call differently depending on the transfer mode on DSS key.
To configure the transfer mode on DSS key via web user interface:
1. Click on Features->Transfer.
2. Select the desired transfer mode from the pull-down list of Transfer Mode via
DSSkey. Depending on your selection:
- If you select Blind Transfer, press the BLF key to blind transfer to the monitored
phone number.
- If you select Attended Transfer, press the BLF key to dial out the monitored phone
number and then you can perform the attended or semi-attended transfer.
- If you select New Call, press the BLF key to place a new call to the monitored user.
3. Click Confirm to accept the change.
For more information on performing call transfer, refer to

Call Recording

You can record calls by pressing a record key on the SIP-T42G IP phone. There are 2
different ways of configuring call recording and they even work differently:
Record: The phone sends SIP INFO message containing a specific header "Record:
on/off" to trigger a recording.
URL Record: The phone sends HTTP URL request to trigger a recording. Contact your
system administrator for the predefined URL.

Advanced Phone Features

Call Transfer on page 65.
77